Troubleshooting tips for automatic CNC pipe end forming Machis a new type of pipe bending tool. It has the advantages of reasonable structure, safe use, convenient operation, reasonable price, fast loading and unloading, easy to carry, multi-purpose of one machine, etc., and occupies a large share in the domestic hydraulic market, mainly used in factories, warehouses, docks, construction, railways, automobiles and other installation pipes and repairs. In addition to having the function of bending the pipe, it can also remove the bending parts and be used as a separate hydraulic jacking machine.

Then, when purchasing back, pay attention to the following points when using:

1. Before operation, please check whether the lubrication points of the machine are short of oil, whether the safety protection device is reliable, whether the motion mechanism is loose, and so on.

2, start the oil pump, check whether the system pressure is maintained within the specified range, if high, it will damage the hydraulic components, waste power, if too low, it will affect the work.

3, adjust the required position and Angle of the parts, and position the parts to the required length.

4, adjust the vertical lifting guide rail, so that the guide mold pressing cylinder forward can clamp tightly iron pipe.

5, so that the clamping cylinder can clamp the iron pipe.

6, the normal operation of the workpiece into the bending die, and the front end contact positioning, step down the foot switch, you can complete.

7. After the work, cut off the power supply and do a good job of cleaning and lubrication.

8, operation in case of emergency, should press the emergency stop button, and then turn the torque switch to the manual position, manual reset, if the fault occurs, please report in time.

Here we talk about eight methods for troubleshooting tips for automatic cnc pipe end forming mach:

1: When operating, it must be operated in strict accordance with the operating regulations (key points).

Two: troubleshooting tips for automatic cnc pipe end forming mach. It must be kept clean. Apply anti-rust grease on unpainted parts.

Three: Before each startup, add lubricating oil at a fixed time, fixed point and quantitatively according to the requirements of the lubrication chart, and the oil should be clean without precipitation.

Four: Regularly check and repair the switch, safety, handle, to ensure its reliable work.

Five: The lubricating oil in the motor bearing should be replaced and filled regularly, and often check whether the motor part is working normally.

Six: Regularly check whether the triangle belt, handle, knob, button is damaged, serious wear should be replaced in time.

Seven: It is strictly prohibited for non-designated personnel to operate the equipment, and it must be stopped when people leave the plane.

8. Refuel, lubricate and clean troubleshooting tips for automatic cnc pipe end forming mach 10 minutes before work every day.

troubleshooting tips for automatic cnc pipe end forming mach https://www.john-sheng.com/Automatic-CNC-pipe-end-forming-machine-for-exhaust-pipe.html